How To Setup Your DSL Modem

How To Setup Your DSL Modem.


1)If you have rebooted the modem and it doesn't log back in you can check the settings in the modem. If it is a Zoom modem there are 2 IP addresses that you can use to log in and check the settings. In the top of the address bar type in http://192.168.1.1 or http://10.0.0.2 and it will bring up a username and password. The username will be "admin" and the password should be "zoomadsl" If not try "admin" for the username and "admin" for the password.

2)If you have a Netgear modem the URL is usually http://192.168.1.1 or you can try http://routerlogin.net. The username is usually admin and the password is password.

3)If you have an Actiontec modem the URL is http://192.168.0.1 and you can follow the instructions here: http://support.actiontec.com/doc_files/GT701D_NCS_Ethernet_DSL_Modem_User_Manual-v1.0_3.0.4.1.1.pdf


4)Once you log into the modem make sure that the Protocol is set to PPPoE.


5)VPI should be set to 0 and VCI should be set to 35


6)The username will be your home phone number@value.net and it should look like this as an example: 6104372221@value.net


7)The password will be "password" all lowercase.


8)Once those settings are in the modem click the Save/Apply button. In older modems choose Save Changes then click Write Settings to Flash.



  • 6 Users Found This Useful
這篇文章有幫助嗎?

相關文章

Connecting DSL Modem

Modem Setup:   1. Installing Phone Filters:   You must install the included Phone Line...

Reboot DSL Modem

1)If you are having an issue with your DSL connection, you might need to reboot your modem....

Bad Modem

Question:Is your Modem Bad?   Answer: If you have to constantly reboot your modem or if there...